表层嵌贴CFRP板条加固混凝土梁抗剪性能的研究

复合材料科学与工程 ›› 2020, Vol. 0 ›› Issue (8): 89-96.

表层嵌贴CFRP板条加固混凝土梁抗剪性能的研究

张智梅, 徐钰淇^*

上海大学土木工程系,上海200444

收稿日期:2019-12-04 出版日期:2020-08-28 发布日期:2020-08-28
通讯作者: 徐钰淇(1994-),男,硕士,主要从事FRP加固方面的研究,xu-yuqi@foxmail.com。
作者简介:张智梅(1972-),女,博士,副教授,主要从事工程结构的抗火和加固方面的研究。

STUDY ON SHEAR RESISTANCE OF CONCRETE BEAM STRENGTHENED WITH NSM CFRP STRIPS

ZHANG Zhi-mei, XU Yu-qi^*

Department of Civil Engineering, Shanghai University, Shanghai 200444, China)

Received:2019-12-04 Online:2020-08-28 Published:2020-08-28

摘要/Abstract

摘要： 为研究采用表层嵌贴法加固后钢筋混凝土梁的抗剪性能,推导加固梁抗剪承载力设计公式。本文基于Abaqus软件,构建表层嵌贴CFRP板条的T型梁模型,研究混凝土强度、配箍率、剪跨比、嵌贴角度、嵌贴间距对加固梁抗剪性能的影响,通过回归得到相关影响因素下的CFRP板条的有效应力表达式,建立表层嵌贴法的加固梁抗剪承载力表达式。研究表明:混凝土强度、剪跨比、板条的嵌贴间距和嵌贴角度对加固梁抗剪性能影响较大,配箍率对加固效果有一定的影响。表层嵌贴法对加固梁的挠度和极限承载力均有提高。将采用本文抗剪承载力表达式计算的结果与相关试验值对比,吻合较好。

关键词: 表层嵌贴法, 抗剪加固, 混凝土梁, 有限元, CFRP

Abstract: At present, most of the research methods for the shear strengthening of concrete beams with near-surface mounted FRP strips (NSM-FRP strips) are experimental research, few of which use finite element analysis, and there is no corresponding code to guide the design. In the relevant design formulas put forward by most scholars, most of the effective strain for FRP are obtained through the direct reduction of its ultimate strength, and some scholars have considered the influence factors on the effective strain Ring, but the calculation result is too large. In order to study the shear behavior of concrete beams strengthened by NSM CFRP strips, and derive the expression of shear capacity of reinforced beams. Based on Abaqus, a T-beam model with NSM CFRP strips was constructed to study the effects of concrete strength, stirrups ratio, shear span ratio, embedding angle and interstitial spacing on the shear resistance of reinforced beams. The effective stress expression of CFRP strip considering the related influencing factors is obtained by regression. And the expression of the shear capacity of the beam strengthened with NSM CFRP strips is established. The results show that the strength of concrete, the shear span ratio, the spacing between the battens and the angle of the battens have a great influence on the shear performance of the strengthened beams, and the ratio of stirrups has a certain influence on the strengthening effect. The results calculated using the shear bearing capacity expression are in good agreement with the relevant experimental values.

Key words: NSM, shear strengthening, concrete beam, FEM, CFRP

中图分类号:

TB332

张智梅, 徐钰淇. 表层嵌贴CFRP板条加固混凝土梁抗剪性能的研究[J]. 复合材料科学与工程, 2020, 0(8): 89-96.

ZHANG Zhi-mei, XU Yu-qi. STUDY ON SHEAR RESISTANCE OF CONCRETE BEAM STRENGTHENED WITH NSM CFRP STRIPS[J]. Composites Science and Engineering, 2020, 0(8): 89-96.

参考文献

[1] 周朝阳, 谭磊, 程小念. FRP抗剪加固钢筋混凝土梁研究综述[J]. 建筑科学与工程学报, 2011, 28(2):1-7.
[2] 王兴国, 岳军辉. RC结构表层嵌入FRP加固技术研究概述[J]. 玻璃钢/复合材料, 2012(4): 124-128.
[3] LORENZIS L D, NANNI A. Shear strengthening of reinforced concrete beams with near surface mounted fiber-reinforced polymer rods[J]. ACI Structural Journal, 2001, 98(1): 60-8.
[4] DIAS S J, BARROS J A. Performance of reinforced concrete T beams strengthened in shear with NSM CFRP laminates[J]. Engineering Structures, 2010, 32(2): 373-84.
[5] 汪昕. 嵌入式碳纤维板条增强混凝土梁受弯与受剪承载力研究[D]. 南京: 东南大学, 2006.
[6] 宗周红, 程怡, 黄学漾, 等. CFRP板加固RC&PPC梁抗剪性能试验研究[J]. 工程力学, 2013, 30(6): 236-246.
[7] 曾宪桃, 任振华. 侧立面嵌贴碳纤维增强塑料板条加固混凝土梁受剪承载力研究[J]. 建筑结构学报, 2014, 35(2): 137-143.
[8] 张海霞, 孙闯, 李程翔. 内嵌FRP筋加固混凝土梁的抗剪性能研究[J]. 沈阳建筑大学学报(自然科学版), 2018, 34(3): 419-429.
[9] DIAS S J, BARROS J A. NSM shear strengthening technique with CFRP laminates applied in high T cross section RC beam[J]. Composites Part B, 2017, 114: 256-267.
[10] DIAS S J, BARROS J A. Experimental behavior of RC beams shear strengthened with NSM CFRP laminates[J]. Strain, 2011, 48(1): 88-100.
[11] 中华人民共和国住房和城乡建设部. 混凝土结构设计规范: GB 50010-2010[S]. 北京: 中国建筑工业出版社, 2011.
[12] 日本建筑学会. 鉄筋コンクリート造建物の終局強度型耐震設計指針. 同解説[S]. 1990.
[13] 刘国瑞. 表面内嵌FRP加固混凝土梁抗剪性能研究[D]. 沈阳: 沈阳建筑大学, 2012.
[14] 樊烽, 姚谏. 有腹筋RC梁表层嵌贴CFRP板的抗剪加固试验研究[J]. 科技导报, 2007, 23(4): 582-586.
[15] 陈莉, 崔士起, 成勃. 嵌贴CFRP板条加固混凝土梁抗剪性能试验研究[J]. 山西建筑, 2009, 35(13): 3-5.
[16] RAHAL K N, RUMAIH H A. Tests on reinforced concrete beams strengthened inshear using near surface mounted CFRP and steel bars[J]. Engineering Structures, 2011, 33(1): 53-62.
[17] RIZZO A, LORENZIS L D. Behavior and capacity of RC beams strengthened in shear with NSM FRP reinforcement[J]. Construction and Building Materials, 2009, 23(4): 55-67.
[18] DIAS S J, BARROS J A. NSM shear strengthening technique with CFRP laminates applied in high-strength concrete beams with or without pre-cracking[J]. Composites: Part B, 2012, 43(2): 290-301.